12/3/2023 0 Comments Overhead radiant heat![]() – Steel hangers with suspension points for both flat and angle mounting of reflectors.įull installation/operation instructions for the Heatwave radiant tube heater (PDF 4.5 MB) – Highly polished material for increased reflectivity. – Highly efficient, wide angled aluminum reflectors – engineered to reflect maximum radiant energy over the largest effective area possible. – Emitter tubes provided with a 20 year burnout guarantee. – Swedged tube for ease of installation – no couplers or clamps required at joints. – Secondary tubes constructed of 16 gauge carbon steel for high emissivity. ![]() – Primary combustion tube made of high temperature, high emissivity specialty alloy. – Emitter tubes are 3″ diameter, 16 gauge North American steel. – Factory ready to accept either 24V or 120V controls. – Flame observation port to visually observe combustion. – Dual air proving switches monitor combustion air and exhaust airflow for safety. Blower motor is externally mounted for ease of accessibility and to simplify intake – air connection (4″ combustion air intake duct adapter comes standard). – Totally enclosed blower motor with internal thermal overload protection. ![]() – Continuous combustion monitoring with three to five ignition trials before 100% safety lockout. – Built with 100% North American made electronic controls. – Reliable electronic hot surface ignition. – Natural gas (model GH40N) and propane (model GH40P) fired models built to order with no field conversions required. Perfect for garages and workshops, the Heatwave can also be used anywhere that space constraints make other heating equipment difficult or impossible to use. At 40,000 BTUH, 8′ in length, and only 8 3/4″ from bottom to top, the Heatwave can fit in smaller shops easily, and can be installed in building with ceilings as low as 8′. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |